![]() Hopefully company will improve these problems! The average person using this mount, should precheck these two items before installing. Had to add a washer under screw head to snug screw to tighten leveling bracket. Put them in by hand before mounting TV and they only went in about half way and stopped. (*Also wish it would tilt down more than 5 degrees).Ģ) The leveling screw that locks TV on Bracket, does not tighten on either of the two brackets, as if the screw, or hole was striped But they are not. Had to fight to remove the tension washer and added a seat washer instead, so tilt angle can be adjusted again if needed. The down sides to these mounts: 1) The ‘T’ tilt adjustment bolt, it is made of plastic and the tension washer that’s part of it, came apart on both mounts, making it tough to loosen tension so we could adjust angle. Simple fix, just needed one slightly larger washer, to make sure it covered hole on bracket. ![]() So bought this Sanus mount because it was similar to the last one and I wouldn’t need to make new holes in the wall But I did need to ream mounting holes on bracket a bit, due to old mount holes were 7-1/8” apart and this one was 6-7/8”. In doing so, needed to change mounting brackets, because old one only fit up to a 45” TV. So we bought two and changer bedroom TV as well. Simple design We just replaced our older 42” 4K TV, that turns out it’s cheaper to upgrade to a 55” 4K, than to repair a simple diode. You can also shift your TV left and right on the wall plate to place your TV exactly where want to – even if your studs are off-center. SANUS includes a comprehensive TV hardware pack to fit most TV’s on the market today. This mount can be installed on wood studs or on concrete – hardware is included for wood stud. Easily level your TV after installation if things don’t end up just right, loosen the screw on the back of the mounting assembly – adjust level, and tighten to hold in place. ![]() You can easily tilt your TV down 15 degrees, perfect for eliminating glare from lights and windows – or to get better a viewing experience if you need to mount your TV above a fireplace. Kit includes a 9.8’ 4K HDMI cable for easy hook-up to components after installation. ![]() Amount of swivel will depend on the size of your TV.Position your TV 1.99 inches from the wall for a clean, low-profile look. This is the SANUS Full-motion TV Mount designed to hold TV’s 32-55 inches and up to 55 pounds.With this mount you can easily extend your TV up to 18 inches out from the wall allowing you to swivel your TV up to 50 degrees left and right. Full-motion TV Mount for 32"-55" TV’s, Includes 9.8’ 4K HDMI Cable ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |